How to Install Your Tower Fan Filter
Installing your Honeywell HY280 tower fan filter
Step 1.
Attach Velcro adhesive strop to the back side of the filter. Before attaching the Velcro strips make sure your fan is clean from any dust or dirt.
Step 2.
Starting at the top just below the remote storage compartment, center the Fan Buddy logo inline with the center of the fan. Peel back the adhesive tape on each side. Make sure the filter is centered and press the Velcro firmly onto the fan.
Step 3.
Pull the adhesive tape back and press the Velcro down towards the bottom of the filter.
Proceed to the other side and repeat from top to bottom.
That’s it your finished.
Watch the HY280 Honeywell Tower Fan Filter installation video.
Download the complete instructions.
Step 1.
Lay your fan on it’s side. Attach Velcro adhesive strip in line with the outside edge of the remote control clip*. Starting at the top and working your way down using the full length of Velcro Strip provided
Step 2.
Starting at the top, line up the Velcro and press both Velcro strips together firmly.*
Note – the filter lays over the remote control hanger. We suggest to remove the three screws and not use it. Or remove and push screws through material. This turns out to be problematic when cleaning the filter. Having to remove it each time.
Step 3.
Proceed to the other side and attach the Velcro strip to the edge of the vent intake.
Starting at the top, line up the Velcro and press both Velcro strips together firmly.
Step 4.
Attach other side of the filter using your hand to smooth out the filter material. That’s it, your finished
Watch the Seville Ultra Slim Fan filter installation video.
Download the complete instructions.
Step 1.
Lay your fan face down. Attach Velcro adhesive strip in line with the outside edge shown.*
Starting at the top 1″ above the fan grill work your way down using the full length of Velcro strip provided.*
Step 2.
With the filter starting at the top, line up the Velcro and press both Velcro strips together firmly.
Step 3.
Proceed to the other side and attach the Velcro strip to the edge of the vent intake.
Starting at the top, line up the Velcro and press both velcro strips together firmly. That’s it you’re finished.
Download the complete instructions.
Step 1.
Before attaching the Velcro strips make sure your fan is clean from any dust or dirt. This will insure proper adhesion of the Velcro strips.
Step 2.
Lay your fan on it’s side. Attach Velcro adhesive strips on each side of intake vent area as indicated here.*
Starting at the top and working your way down to the bottom of the fan. Use the full length of Velcro strip provided.*
Step 3.
Starting at the top press filter and Velcro together firmly working your way towards the bottom of the fan.
Step 4.
Proceed to the other side and repeat from top to bottom.
That’s it you’re finished!
Watch the Lasko windcurve fan filter installation video.
Download the complete instructions.
Fan Buddy Tower Fan Air Filter Installation Steps
How to Install a Lasko 2535 52″ Oscillating Pedestal Fan Filter
How to Install a Lasko 2511 Tower Fan 36″ Fan Filter
How to Install a Fan Filter on a Bionaire 4002 Tower Fan
How to Install a Fan Filter to a Lasko
